Ir al contenido de la página

Behringer X1

9 Valoraciones de los clientes

4 / 5

Para poder evaluar un producto deber estar registrado en su centro de clientes.

Importante: Con fin de evitar evaluaciones en base a rumores o mitos populares, solo permitimos en nuestro website evaluaciones por clientes que hayan comprado el producto con nosotros.

Tras de acceder a su centro de clientes encuentra en Centro de clientes "Evaluar productos" todos los artículos que puede evaluar.

Fabricación

7 Reseñas

Behringer X1
19,90 €
Todos los precios incluyen IVA
Disponible en varios meses
Disponible en varios meses

Ese artículo se encuentra agotado y ha sido reordenado. Lamentablemente nuestro proveedor no nos puede garantizar el suministro dentro de los próximos tres meses. Le recomendamos que busque una alternativa en nuestra tienda.

Información sobre envíos
1
google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
TD
Tedis Dess 13.08.2020
Hi! I got this crossfader fiew days ago. Packed in cardboard box, and ESD safe bag. Everything nice, but, when i , folowing instruction, connected it to my mixer, nothing happened. I searched in internet, but there was no information available what can be wrong, and than i started to investigate connections, i found that wiring does not correspond to connector onboard. I found that middle pin from 3 pins is right one, but other two from sides should be crossed. So i did that, and now its works. Its possible that for other hardware revisions of DDM4000 could be different. My one is from 2007.
Fabricación
0
0
Reportar evaluación

Reportar evaluación

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
D
Behringer X1 Replacement/upgrade Fader
Damein 26.11.2013
After some considerable use the original crossfader on my DDM4000 needed replacing and the X1 optical fader represented a significant upgrade for a small amount more than the standard replacement item. The fader came with good fitting instructions but I did find space a bit tight when clipping the cable into place.

If you have fat fingers I would suggest removing the whole faceplate and not just the faderplate to fit this fader.

You can set the cut in from each side so its perfect for scratch djs. The tension setting doesnt seem to tighten things up too much so the fader glides very smoothly. I dont see this being an issue as scratch Djs will only really be potential buyers for this.

In operation It is a huge improvement on the original and really turns a already good mixer into a great mixer. I noticed a clear improvement on my cuts.
Fabricación
0
0
Reportar evaluación

Reportar evaluación

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
l
wiring problem
lawts 26.07.2023
works as it should but i had to modify a wire
Fabricación
0
0
Reportar evaluación

Reportar evaluación

Behringer X1