Ir al contenido de la página

Convertidor USB compacto para pedales de efectos de 9 V

  • Convierte un cargador, un Powerbank o una conexión USB de ordenador en una fuente de alimentación para pedales de efectos
  • Proporciona corriente estable para pedales de efectos y otros dispositivos
  • Entrada aislada
  • Tensión de entrada: 5 - 9 V DC
  • Tensión de salida: 9 V DC
  • Corriente máxima de salida: 400 mA
  • Polaridad de entrada: Centro negativo
  • Polaridad de salida: Centro negativo
  • Polaridad invertida y protección contra sobrecarga
  • Medidas: 16 x 16 x 63 mm
  • Peso: 17 g
  • Incluye cable USB DC y cable de conexión DC
  • Disponible desde Agosto 2019
  • número de artículo 460430
  • Precio por 1 Unidad(es)
  • Corriente continua / alterna DC
  • Potencia de salida en mA 400 mA
  • 9 V
  • 12 V No
  • 18 V No
  • Otros voltajes secundarios No
  • Multi-alimentador No
9,60 €
Todos los precios incluyen IVA
En stock
1

84 Valoraciones de los clientes

4.8 / 5

Fabricación

61 Reseñas

MF
Miguel Fernández
Miguel Fm 15.11.2021
Práctico adaptador para usar cualquier ver Powerbank USB y alimentar pedales y otros aparatos a 9v.
Fabricación
2
0
Reportar evaluación

Reportar evaluación

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
a
Joyo Power Converted POG2
abcalypso 30.12.2019
Having just spent an hour using this product intensively; This product works 100%. PLEASE READ BELOW FOR YOUR SAFETY BEFORE ATTEMPTING SIMILAR TEST ON YOUR EQUIPMENT.
1. I plugged into: Electro Harmonix POG2 (Poly Octave Generator requiring centre-neg -9V- sucking up 1.8ma ...according to adapter specs.)
2. Centre Negative = Yes (out of the box correct...check your effect box before use...just in case you have a positive centre-pole!)
3. 1 hour use: slightly warm after 1 hour non-stop playing.
4. Powered by an (old) thinline phone battery pack (Specs: DC 5V/1A-Output DC5V/1A...4000mAh/14.8Wh)
5. Used one charge-light (out of 5)...no glitches/switch-off's etc
6. POG2 pedal running through a Roland Mobile amp running on its own battery power.
Please note: Knowing your equipment is 9V is not enough info if you wish to have success and safe use! Make sure you check the amount it requires (e.g. 1ma-2ma-or much more?). JOYO claim you can go up to 400ma...though I would suggest staying below that mark especially if you have an expensive pedal/effects box.
Like? YES...IT WORKS AND IS EXACTLY WHAT I NEED TO GO MOBILE.
Cons: None so far...time will tell if it remains reliable and doesn't break the pedal electronics at a later stage.
Fabricación
6
0
Reportar evaluación

Reportar evaluación

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
LJ
An excellent little devil, can be considered a gig-saver.
Lighthouse J. 01.11.2019
I bought, received and tested this very useful little device:

I connected it's input to a recently bought SilverCrest 10.000 mA powerbank, which was fully charged.
The output was connected to my Zoom G3Xn multi-effect-processor, that is normally powered by a 9V DC - 500 mA wall-charger (which means it will consume about 400 mA, the maximum that the 'Joyo' can deliver).

- The Zoom G3Xn became immediately active and was continuously used during 7 hours and 45 minutes, after which the SilverCrest powerbank was empty.

- Power dissipation was transformed into a hardly noticeable rise of temperature near the output section of the 'Joyo'-device, which is remarkable, since it had to deliver it's maximum all the time it was used.

- There was no measureable (noise) influence on the audio-signal: It was absolutely clean.

Conclusion: This is an excellent little devil, very useful on stage, and can be considered a gig-saver there!
Fabricación
3
1
Reportar evaluación

Reportar evaluación

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
D
It does the job
DenisZ 12.02.2022
Im using it to power my multieffect with a power bank and it does the job.
Fabricación
0
0
Reportar evaluación

Reportar evaluación