Ir al contenido de la página

Conector jack

  • Para montaje de cable
  • Estéreo
  • Con cierre
  • número de artículo 105171
  • Precio por 1 Unidad(es)
  • Instalación No
  • Mono/estéreo Estéreo
  • En ángulo No
  • Tipo TRS (stero, simétrico)
8,90 €
Todos los precios incluyen IVA
En stock
1

180 Valoraciones de los clientes

4.8 / 5

Fabricación

55 Reseñas

im
buen producto
ivan montornes 01.08.2016
facil de soldar y montaje sin herramientas neutrik son los mejores conectores nunca fallan los recomiendo
Fabricación
0
0
Reportar evaluación

Reportar evaluación

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
2
Headphone extension
22minx 08.11.2021
Easy to solder, Neutrick high standard. I use it for extending my headphones signal. Works great, lock feature is amazing. Works with 80 and 250 ohm headphones.
Fabricación
0
0
Reportar evaluación

Reportar evaluación

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
aT
Good but takes some tricks
a Tamás 30.10.2025
Made a 3.5mm to 6.35mm TRS adapter with it.
Pros:
It takes up to 8mm diameter cables without needing a different chuck and boot.
It can do only 2 poles as well, for instance a TS to RCA adapter.
The pins are positioned in a triangle, similarly to an XLR connector, which is easier to solder than tipical pin positions on TRS connectors.
Cons:
The area around the pin cups is plastic and may melt if you get too close with the iron.
The latch lock is very hard to push down - the Neutrik website says it has a locking force of more than 80 Newtons. However, taking out the spring under the red latch lock can make it a lot easier - just slide the bar to the end to lock and slide back to unlock.
The boot is a little difficult to put on without creating a gap between the housing and the connector opening. A workaround is to screw the boot halfway on, then screw the small screw into the housing and then screw the boot fully on.
Fabricación
0
0
Reportar evaluación

Reportar evaluación

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
J
Neutrik NJ3 FC-6
James007 11.06.2013
These are Neutrik so you can be rest assured with the quality. The locking input works well to avoid the jack slipping out. Bear in mind that this will need soldering but it's pretty easy to do after you've done a few different leads and sockets.
Fabricación
0
0
Reportar evaluación

Reportar evaluación