RME DPS-2 B-Stock

Linear Power Supply for RME ADI-2 Series

• Output 1 (linear): classic DC output with multi-stage passive and active filters, 30,000 µF capacitor bank, ferrite choke and an active output filter with hybrid voltage regulator
• Output 2 (µFilter) is based on the RME µFilter technology, the signal is additionally processed from the pre-filtered linear output with active filters, the output voltage is measured and regulated directly at the DC connector by means of the supplied DC special cable using a sensor
• 60 VA audio toroidal transformer with additional insulation winding and magnetic shielding tape for hum- and noise-free operation
• Ground lift switch
• Two multi-coloured front LEDs to indicate operating states and errors (existing input and output voltage, overload, undervoltage, short circuit)
• Recessed push switch for AutoDark mode
• Exterior dimensions (W x H x D): 130 x 52 x 205 mm
• Weight: 1.89 kg

Connections:

• DC output Linear 12 V 2.5 A
• DC output µFilter 12 V 2.5 A
• GND screw terminal
• Input for power cable