Rockboard LED Damper Small

Tengo varios pedales que me dejan ciego cada vez que los activo, más aun cuando tengo que usarlos en salas oscuras o de noche.
Ha sido colocarle estos cacharrejos y, no solo son discretos, si no que, cuando se notan que están ahí, tienen un diseño tan estético que hasta elevan el diseño del pedal en cuestión.
Al menos en mi opinión.

Y cumplen su función, ahora no tengo una luz inferior que hace que poner focos al escenario sea inútil porque ya voy iluminado. Son solo puntitos de color que puedo situar rápido y saber cuando están o no activos.

Yep. It's a little sticky faceted cover that goes over your bright pedal LEDs.
The plastic is very slightly smoked to reduce the brightness, and overall it works well.
The adhesive used is good enough when the pedals live on a board, but if you carried them loose in your gig bag the damper may get knocked off.
I would have liked the base of the damper to be made from the same clear plastic so you can see more of the light.
As it is the silver base blocks a lot of the light from anything other that stood dead centre over the pedal. Having some light cast off to the sides would be a help.

As it is though, these diffuse the light really well, they also look good too.
I have them installed on a Vemuram Rage E and RockFabrik Mind Abuse. Both pedals have searing LEDs bit are nicely tamed by these dampers.
I do think in a lot of cases the plain white 'bubble' dampers would be just as good, if not better.
These just look a bit flashier, but do the same job and cost a bit more.

These are a total game changer for my pedalboard. Some of my LEDs are *super* bright and basically blinding, so using these self-adhesive dimmers/dampers on those pedals is amazing. They're small enough and seamless enough to look like it's always been there and doesn't totally kill the look for your pedals. Highly recommended if you have pedals like a MXR 10 band EQ, Fender ABY switch, or something like a Walrus Voyager OD pedal with super bright LEDs!