Ir al contenido de la página

Caja para teclado

  • Adecuada para Yamaha Montage M8X
  • El teclado se puede tocar sin necesidad de sacarlo de la parte inferior de la caja
  • Tapa Typ 3-88
  • Material: Multiplex de 6,8 mm
  • Acolchado de gomaespuma
  • Cantos de aluminio 30 x 30 mm
  • 4 esquinas en L medianas
  • 4 esquinas de bola medianas
  • 2 esquinas de bola con L medianas
  • 4 cierres de mariposa medianos
  • 4 asas plegables medianas
  • 2 ruedas de montaje en esquina de 48 mm (abajo a la derecha)
  • 6 pies de goma de 38 x 20 mm
  • Medidas exteriores (An x Pr x Al): 1552 x 528 x 242 mm
  • Peso: 17,4 kg
  • Color: Marrón fenol
  • Fabricado en Alemania
  • Disponible desde Febrero 2026
  • número de artículo 634838
  • Precio por 1 Unidad(es)
  • Asas 0
  • Asas plegables 4
  • Ruedas No
  • Ancho exterior (mm) 1552 mm
  • Profundidad exterior (mm) 528 mm
  • Altura exterior (mm) 242 mm
  • Peso 17,4 kg
  • Equipamiento opcional Ninguna
324 €
Todos los precios incluyen IVA
En stock
1

1 Valoraciones de los clientes

4 / 5

Estabilidad

Manipulación

Fabricación

1 Reseña

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
T
Amazing intercontinental speed and pricing
Truebadoor 13.08.2026
I ordered this equipment case for the Yamaha Montage M8x 04/08/26 and received it in Canada on 12/08/26. I would have had it on 08/08/26 because it reached Calgary, Canada then, but as I live in the sub-arctic, it was sent out from there by truck 1,748 kms north to Yellowknife, Northwest Territories and it took more days. It was fast service considering.

The only issue I have is that the case's fit for the Montage M8x is so perfect, that putting the instrument in the bottom of the case tears the foam on 4 corners (ever so slightly) as it is "dropped in place". It might have been better if the design allowed some wiggle room. However, it is very high quality and the case provides moore than adequate protection for my precious instrument.

I had pre-supposed that since the bottom part that sits under the synth would allow cables to be connected so all you would have had to do was take the larger part of the case off the top of the synth and it would sit on its bottom until after the gig, minimizing handling of the heavy instrument. It doesn't seem like the clearances would allow this, as the ports are covered by the back of the case. Oh well...
Estabilidad
Manipulación
Fabricación
0
0
Reportar evaluación

Reportar evaluación