Ir al contenido de la página

Set de Retenedores de Cuerdas

  • Cantidad: 2 unidades
  • Con 1 casquillo espaciador de 2,5 mm y 1 de 5 mm
  • Acabado: Cromo
  • Fabricados en Japón
  • Disponible desde Enero 2024
  • número de artículo 565680
  • Precio por 1 Unidad(es)
3,77 €
Todos los precios incluyen IVA
En stock
1

7 Valoraciones de los clientes

4 / 5

Fabricación

5 Reseñas

S2
Buen producto
Santiago 21 12.10.2025
Lo que se puede esperar de Gotoh, un producto de calidad. En este caso vienen dos guías de cuerdas con varias piezas para el pie que se pueden combinar para variar la altura.
Fabricación
0
0
Reportar evaluación

Reportar evaluación

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
LP
Quality parts
Lord Porkchop 29.08.2026
I got these for a Player II tele mostly to smoothen tuning for the two highest strings, and they seem to do the job adequately. Not perfect but that's the way it is with flat headstocks.

Fender says their hardware is chrome/nickel, and compared to these string retainers I would say that their tuners and the old stock retainer were more towards nickel, whereas these are clearly chrome. Doesn't make much difference on a part of this size, but if I would do it again I'd try the nickel ones.

The quality of these Gotohs seems good. I can't feel any sharp edges with my fingers and no strings have snapped yet.

Since I wanted to use the "spacers" to raise the strings I also had to use the longer screws that they came with. Those seem to be as wide as the originals, but the threading is very slightly different. I screwed them in anyway and they seem to hold fine. Possibly there could be problems if you'd try to go back to stock hardware.
Fabricación
0
0
Reportar evaluación

Reportar evaluación

google translate gb
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
a
Replacement for a HB TE-52 Telecaster
andrea00 28.06.2026
Good replacement for the original HB TE-52 String retainers. Be careful that screws are bigger and you will need to enlarge the holes. 2.5 mm drill bit recommended.
Fabricación
0
0
Reportar evaluación

Reportar evaluación

google translate de
Lamentablemente hubo un error. Por favor, inténtelo de nuevo más tarde.
D
Tut was es soll
Dieter850 27.07.2025
Hab die Teile bei meinem selbstgebauten Strat-Hals verbaut. Die kleinen Schrauben halten dem Seitenzug stand und die Teile tun was sie sollen. Kaufempfehlung!
Fabricación
0
0
Reportar evaluación

Reportar evaluación